FT-2040 Bill Counter
1.With MG detection -With UV detection
2.With double-/half-/chain-note detection
3.Suitable for most of the currency in the world -Automatic start/stop/cleaning -With batch/add functions -Low noise with counting
Different Operation Modes
CUR – Allows you to keep counting bills
ADD – Continuous bill counting
BATCH – Separate bills into preset qualities
VALUE – Calculate the value of the counted bills
Adjusting the Machine’s Feeding Gap Properly
To make sure that the machine’s feeding gap is adjusted properly, you have to consider the following:
Too loose. If the feeding gap is too loose, the bills will slide in without resistance. Turn it to the right side to tighten.
Optimal position. The bill slides in with a bit of resistance if the feeding gap is in optimal position.
Too tight. The bill does not slide in when the feeding gap is too tight. Turn left to loosen.